Final Assembly; X 1 1/2-Inch Nylon - Hangar 9 Taylorcraft 20cc ARF Assembly Manual

Step 4
Maintain approximately a 3/32-inch (2.5mm) gap
between the tape marker and the front of the
windshield to ensure that when the cowl is installed it
does not contact the windshield.
Step 5
Use canopy glue to install the cowl baffles on the
inside of the cowl inlets. Place the cowl nose down on
a flat surface and allow the glue to cure fully.
Hangar 9 Taylorcraft 20cc Assembly Manual

Final Assembly

Parts Required
Fuselage Wing panels
Radio cover Top window
Seat Wing tube
Strut pin (4) Keeper (4)
Pilot figure Propeller
Cowling Cable tie (small)
#4 washer (4) Silicone pin spacer (4)
4-40 x 1/2-inch button head machine screw (4)
#4 x 1/4-inch self-tapping screw (12)
1/4-20 x 1 1/2-inch nylon wing bolt (2)
Tools Required
Thin CA #1 Phillips screwdriver
Threadlock 9/32-inch open-end wrench
5/64-inch hex wrench
Step 1
Apply 1–2 drops of thin CA to each of the radio cover
mounting holes.
Step 2
Use a #1 Phillips screwdriver to install the radio cover
with four #4 x 1/4-inch self-tapping screws. Note the
orientation of the magnets on the cover; the single
magnet goes to the front of the fuselage.
Step 3
Place the seat in position on the radio cover.
45