Hangar 9 Taylorcraft 20cc ARF Assembly Manual page 29

Step 12
Use pliers to form a bend in the throttle pushrod so
that the end of the connector is offset 3/8-inch.
Step 13
Insert the throttle pushrod into the nylon pushrod
housing in the firewall.
Hangar 9 Taylorcraft 20cc Assembly Manual
Step 14
Locate the carburetor intake funnel, gasket and the
two 4mmx 40mm mounting bolts. Use a 4mm hex
wrench to install the carburetor on the engine.
Step 15
Reattach the ball link connector to the throttle arm.
Step 16
The carburetor has a spring return that assists in
returning the throttle to idle. Verify that the throttle is
completely closed by pulling the pushrod rearwards.
Use a felt-tipped pen to mark the position of the
centered servo arm on the pushrod.
Step 17
Use a felt-tipped pen to make a mark on the throttle
pushrod 1/8-inch behind the first mark.
29