Section.11:.Radio.installation - Hangar 9 P-51D 1.50 ARF Assembly Manual

Section 11: Radio Installation
Required Parts
•.Fuselage.assembly.
•.Receiver.
•.Switch.harness.
•.3mm.x.6mm.screw.(2)
•.Servos.(4).(not.included)
•.Connector.backplate.(2)
Required Tools and Adhesives
•.Thin.CA.

.Step 1
Install.the.recommended.servo.hardware.(grommets..
and.eyelets).supplied.with.your.radio.system.onto.four.
servos.(elevator.(2),.rudder.and.throttle)..Install.the..
servos.as.shown..Secure.the.servos.using.the.screws.
provided.with.the.servos.
34
•.1/4".foam
•.Receiver.battery
•.Brass.connector.(2)
•.Hobby.knife

.Step 2
Mount.the.radio.switch.in.the.side.of.the.fuselage..Glue.
small.scraps.of.plywood.to.the.balsa.sheeting.inside.the.
fuselage.to.give.the.screws.something.to.bite.into.
Note:.Using.two.standard.rotation.servos.and.
a.standard.Y-harness.for.the.elevators.will.
result.in.them.moving.in.opposite.directions.
instead.of.the.same.direction..As.such,.the.
elevator.servo.installation.will.either.require.
the.use.of.one.reversed.rotation.servo.and.
one.standard.rotation.servo.or.a.reversing.
Y-harness..It.is.highly.recommended.to.use.a.
computer.radio.or.a.JR
the.two.elevator.servos.to.operate.properly.

.Step 3
Wrap.the.receiver.and.receiver.battery.in.1/4".foam...
Plug.the.servos.and.servo.extensions.into.the.receiver..
Mount.the.receiver.and.battery.in.the.fuselage.so.they.
won't.move.in.flight.
® .MatchBox ™ .to.link.