Radio Installation - Hangar 9 toledo special 40 Assembly Manual

Radio Installation

Required Parts
Fuselage assembly Receiver
Receiver battery Switch harness
Hook and loop strap Radio foam
Y-harness (1) or 6-inch (152mm) servo extension (2)
Servo with hardware (3)
(2 if constructing the EP version)
Tools and Adhesives
Phillips screwdriver: #1 Thin CA
Hobby knife with #11 blade Hook and loop tape
Scissors

Step 1
Install the grommets and brass eyelets in three servos for
the elevator, rudder and throttle.
note: If you are building the EP version, you only need to
prepare two servos for rudder and elevator at this time.
8

Step 2
Use a #1 Phillips screwdriver to thread a servo mounting
screw into the holes in the radio tray for mounting the
servos. Apply a drop or two of thin CA into each hole to
harden the threads made by the screw. This will provide a
much more secure mounting of the servos than if this step
were skipped.

Step 3
Use the hardware to mount the rudder and elevator servos in
the servo tray. Make sure the output of the servos face to the
rear of the fuselage. Tighten the screws using a #1 Phillips
screwdriver. Make sure to guide the leads from the servos
through the hole behind the opening for the throttle servo
when placing the servos in the radio tray.

Step 4
Mount the throttle servo in the radio tray as shown using a #1
Phillips screwdriver and the screws provided with the servo.
note: If you are building the EP version you will not
need to install the throttle servo.
Hangar 9 Toledo Special Assembly Manual