Nylon - Hangar 9 Taylorcraft 20cc ARF Assembly Manual

Step 6
Locate the 10 1/4-inch lower rear stabilizer strut.
Install it on the lower surface of the stabilizer over the
screw inserted in Step 5 and thread on a 4-40 nylon
lock nut.
Step 7
Use a 5/64-inch hex wrench and 1/4-inch open-end
wrench to tighten the brass strap and rear strut to the
stabilizer.
Hangar 9 Taylorcraft 20cc Assembly Manual
Step 8
Attach the inboard end of the rear strut to the top of
the aluminum tab with a 4-40 x 1/4-inch button head
machine screw and 4-40 nylon locknut.
Step 9
Use a 5/64-inch hex wrench and 1/4-inch open-end
wrench to tighten the rear strut to the aluminum tab.
Step 10
Thread a 4-40 rod end onto the threaded section of
the upper brace wire and adjust it until the hole is
aligned with the hole in the brass tab.
Step 11
Place a small amount of threadlock on a 4-40 x 1/4-
inch button head machine screw and install it with a
5/64-inch hex wrench.
17