Table of Contents
Advertisement
Step 8
Loosen the machine screws holding the wheel collars and
position the wheel so it does not rub on the wheel pant.
Tighten the screws to secure the position of the wheel
collars. Make sure to use threadlock on both machine
screws so they do not vibrate loose.
Section 10: Radio and Pilot Installation
Required Parts
• Fuselage assembly
• Pilot support brace
• Switch harness
• Clevis (2)
• Snap link (2)
3
• 24
/
-inch (630mm) threaded pushrod (rudder)
4
1
• 23
/
-inch (590mm) threaded pushrod (elevator)
4
Required Tools and Adhesives
• Phillips screwdriver
• Pin drill
• Drill bit: 5/64-inch (2mm) • Pliers
• Pilot
• Receiver
• Y-harness
• Clevis retainer (2)
• Thin CA
• Medium CA
Section 9: Landing Gear Installation
Step 9
The tail wheel is installed following the same procedure
as the main wheels, only you will be using two 1/16-inch
wheel collars with setscrews and will be tightening them
using the provided hex wrench. Again, use threadlock on
the setscrews to prevent vibration from causing the loss of
your tail wheel.
Step 1
Install the rudder and elevator servos in the fuselage.
39
Hide quick links:
Advertisement
Table of Contents
