Fuel System Connections - Hangar 9 Taylorcraft 20cc ARF Assembly Manual

Step 14
Remove the cowling and use a sanding drum in a
rotary tool to make the opening for the exhaust.
Step 15
Remove the propeller nut and washer and set them
aside. Apply threadlock to the muffler bolts and install
the muffler. Install the cowling and check the cutouts
for clearance with the plug cap, intake funnel and
exhaust. Make any necessary adjustments so that the
engine does not contact the cowling.
Hangar 9 Taylorcraft 20cc Assembly Manual

Fuel System Connections

Required Parts
Fuselage Cowling
Fuel dot Fuel tubing
Small cable tie
Required Tools
Ruler Tapered reamer
Felt-tipped pen Sidecutters
Step 1
Remove the cowling. Use sidecutters to remove an
approximately 1 1/2-inch length from the end of the
fuel feed line and insert a tee fitting.
Step 2
Connect the fuel feed line to the carburetor inlet.
Attach an 8-inch length of fuel tubing to the open leg
of the fuel tee, this will become the fuel fill line.
Step 3
Attach a small cable tie 3/8-inch from the end of the
vent line. Insert the fuel dot plug into the feed line.
Place both lines in the cooling exit ramp on the
fuselage bottom temporarily.
33