Inch Wheel - Hangar 9 Taylorcraft 20cc ARF Assembly Manual

Step 6
Slide a 5/16-in wheel collar on the axle to the inner flat
spot. Apply threadlock to the 3mm x 6mm cap screw
and use a 2.5mm hex wrench to secure the wheel
collar to the axle.
Step 7
Slide a 3-inch wheel onto the axle.
20
Step 8
Slide a second wheel collar on to the axle against the
wheel. Use threadlock on the wheel collar retaining
screw and tighten it to the axle on the flat spot using a
2.5mm hex wrench.
Check that the wheel rotates freely, adjust the wheel
collar location if necessary. A small drop of lightweight
oil can be applied to help the wheel move easily.
Step 9
Slide one of the wheel pants over the wheel and into
place against the landing gear leg. Note that there is a
left and right wheel pant. Slide a #4 washer onto each
of the 4-40 x 1/2-inch button head machine screws.
Apply a drop of threadlock to each screw and use a
5/64-inch hex wrench to tighten them in place and
secure the wheel pant to the landing gear.
Step 10
Locate the four 6-32 x 3/4-inch button head machine
screws and place a #6 washer on each screw.
Hangar 9 Taylorcraft 20cc Assembly Manual