Rear - Hangar 9 Taylorcraft 20cc ARF Assembly Manual

Step 2
Place the strut attach brackets into the openings in
the lower wing surface and use a 3/32-inch hex
wrench to secure each one with two 4-40 x 5/8-inch
socket head cap screws.
Step 3
Thread the jury strut attach fittings into the lower wing
surface until the shoulder of the fitting is flush with the
wing surface. The flat sides of the fitting will be
oriented forward and aft.
Hangar 9 Taylorcraft 20cc Assembly Manual
Step 4
Attach a jury strut to the outboard side of each of the
attached fittings with a 4-40 x 3/8-inch button head
machine screw, #4 washer and 4-40 nylon lock nut.
Tighten the strut to the fitting with a 5/64-inch hex
wrench and 1/4-inch open-ended wrench.
Note: All the jury struts are the same.
Step 5
Locate the wing struts. Each of the four struts is
different, the forward strut measures 20 1/2-inches
long, the rear 21 1/8-inches and the attach bracket on
the strut faces the wing surface. Use a 5/64-inch hex
wrench and 1/4-inch wrench to attach the struts to the
strut fittings with a 4-40 x 1/2-inch button head
machine screw and 4-40 nylon locknut.
Step 6
Use a 4-40 x 3/8-inch button head machine screw to
connect each jury strut to the attachment bracket on
the wing strut.
39