Radio Installation - Hangar 9 Cub Crafters XCub 60cc Instruction Manual

119. Slide the hinge into position. Position the hinge so it is
perpendicular to the hinge line when fully defl ected.
120. Insert the hinge so the center of the hinge point aligns with
the front edge of the bevel on the control surface. Check that
the hinge can move freely. Use a paper towel and isopropyl
alcohol to remove any excess epoxy. Allow the epoxy to fully
cure for all hinges before proceeding.
121. Check the fi t of the hinges from the elevators to the stabilizer.
Once the fi t has been verifi ed, mix 1/2 ounce (15mL) of epoxy.
Apply epoxy to the hinges and pockets in the stabilizer. Fit the
hinges, pressing the elevators fi rmly against the stabilizer.
Use a paper towel and isopropyl alcohol to remove any
excess epoxy. Use low-tack tape to hold the elevators tight
against the stabilizer until the epoxy fully cures.
122. Tape the string in the rudder to the lead for the position light.
123. Use the string to pull the wire through the rudder.
Cub Crafters XCub 60cc
124. Use a small amount of epoxy of contact adhesive to glue the
position light in the rudder.
125. Guide the wiring into the fuselage into the cockpit area in the
fuselage.
 Attach the wiring to a long piece of wire or tubing
to help guide teh light wire into the fuselage.
126. Check the fi t of the hinges from the rudder to the fi n. Once
the fi t is verifi ed, mix 15g of epoxy. Apply epoxy to the hinges
and pockets in the fi n. Fit the hinges, pressing the rudder
fi rmly against the fi n. Use a paper towel and isopropyl alcohol
to remove any excess epoxy. Make sure to fully insert the
wire for the navigation light into the fuselage. Allow the epoxy
to fully cure before proceeding.
 RADIO INSTALLATION
127. Remove the radio hatch cover from the fuselage and place it
in a safe location.
128. Install the rudder and elevator servos in the fuselage. Make
sure to prepare the servos with the grommets and eyelets.
The mounting holes will need to be drilled and prepared
before the screws can be installed. The rudder servo is the
center servo.
23 EN