Hangar 9 Taylorcraft 20cc ARF Assembly Manual page 8

Step 2
Slide the fin down until it is fully engaged in the
fuselage slots.
Step 3
Separate the stabilizer halves from each other.
8
Step 4
Slide the stabilizer joiner rods through the holes in the
base of the fin and slide the stabilizer halves against
each side of the fin.
Step 5
Locate the four 6-32 x 1-inch button head hex bolts.
Place a drop of threadlock on the end of the threads.
Step 6
Use a 3/32-inch hex wrench to install the four
stabilizer bolts. Use care to not tighten the bolts
excessively and crush the stabilizer structure.
Hangar 9 Taylorcraft 20cc Assembly Manual