Tail Installation; Radio Compartment - Hangar 9 Taylorcraft 20cc ARF Assembly Manual

Step 6
Use a #1 Phillips screwdriver to remove the stock
servo arms from the servos. Replace the servo screw.
Step 7
Use a #1 Phillips screwdriver to install the rudder and
elevator servos. The elevator servos (outer locations)
have the output shaft towards the tail, the rudder servo
mounts in the center with the output shaft forward.
Hangar 9 Taylorcraft 20cc Assembly Manual
Step 7
This shows the rudder and elevator servos installed.
Step 8
Route the servo leads forward into the radio
compartment through the holes in the bulkhead.

Tail Installation

Required Parts
Fuselage Fin with rudder
Stabilizer with elevators
Required Tools
Threadlock 3/32-inch hex wrench
Step 1
Engage the fin post in the slot in the rear of the
fuselage behind the hold-down plate.
7