Steel - Hangar 9 Taylorcraft 20cc ARF Assembly Manual

Step 6
Use your radio or a JR MatchMaker to center the
elevator servo and install the servo arm using a #1
Phillips screwdriver.
Step 7
Adjust the clevis so that the elevator is centered when
connected to the center hole in the elevator horn.
10
Step 8
Use a ruler to check the alignment of the elevator with
the stabilizer as the clevis is being adjusted.
Step 9
Locate the coil of coated steel pull-pull cable. Uncoil
the cable and fold it against itself to find the center.
Use sidecutters to cut the cable into two equal lengths.
Step 10
Use a hobby knife with a #11 blade to debur the inside
of each end of the copper crimp. This will make it easier
to double the cable through the crimp.
Step 11
Slide a copper crimp onto the end of the pull-pull
cable.
Hangar 9 Taylorcraft 20cc Assembly Manual