Wing Strut Assembly; Jury Strut - Hangar 9 Taylorcraft 20cc ARF Assembly Manual

Step 19
Make sure that the aileron servo is centered, and
adjust the pushrod to length. Attach one clevis to the
outer servo arm hole, the other to the middle hole on
the aileron control horn.
Step 20
Place a drop of threadlock at the end of each clevis.
38
Step 21
Use a 3/16-inch open-ended wrench to tighten each
4-40 hex nut against the clevis.
Step 22
Repeat steps 1 through 21 to install the aileron servo
and linkage in the opposite wing panel.

Wing Strut Assembly

Parts Required
Wing panels Wing Strut (4)

Jury strut (6)

Strut fitting (wing) (4)
#4 washer (4) Strut fitting (fuselage) (2)
5mm hex nut (4) 4-40 nylon lock nut (8)
Strut end (4) Jury strut fitting (4)
#6 washer (4)
4-40 x 3/8-inch button head machine screw (8)
4-40 x 1/2-inch button head machine screw (4)
4-40 x 5/8-inch socket head cap screw (8)
6-32 x 1/2-inch button head machine screw (4)
Tools Required
Threadlock 3/32-inch hex wrench
1/4-inch wrench 5/64-inch hex wrench
Step 1
Apply a drop of threadlock to the end of a 4-40 x 5/8-
inch socket head cap screw.
Hangar 9 Taylorcraft 20cc Assembly Manual