Additional Information; Replacing Internal Components; Hard Disk - Avaya BCM50 Hardware Installation Manual

Hide thumbs Also See for BCM50:

Table of Contents

BCM50 Hardware & Installation

Additional Information

The following sections contain procedures that may not be necessary in all

installations.

Each of the BCM Platforms are fitted with a 40 GB Maxtor SATA hard disk.

SATA: Serial ATA – A newer type of hard disk controller allowing faster data

transfer than EIDE controllers. The SATA cable from motherboard to hard

drive is significantly narrower than the IDE cables

Required Equipment

Before commencing hard disk maintenance functions, you will require the

following equipment:

 Anti-static wrist-strap.

 Phillips #2 screwdriver.

You should also prepare the BCM for the maintenance procedure to take

place.

1. Check for a recent backup of the BCM50 programming. If there is no

recent backup, use Element Manager to back up all of the system data.

2. Use Element Manager to shut down the BCM50 system.

3. Shut down the BCM50.

4. Disconnect all cables.

NN40011-002 Issue 1.2 BCM50 Rls 6.0

Table of Contents