Applying The Factory Image - Avaya BCM50 Hardware Installation Manual

9. The upgrade files will then be uploaded to the BCM.
10. When uploaded, the files will be applied.
11. When the upgrade is complete, a confirmation box will display. Click
OK.
12. The system may automatically reboot if this is a requirement of the
upgrade.

Applying the Factory Image

When the BCM has been upgraded it is highly recommended to apply the
Factory Image. This is the case when upgrading from Rls 1.0 to Rls 3.0, or Rls
2.0/3.0/5.0 to Rls 6.0. Applying the Factory Image will ensure that the BCM
software version will not revert to its original state, if a Software Reset (also
known as a Level 2 Reset) is performed on the BCM.
The Factory Image is applied using the same method as applying the upgrade
files, i.e. in the Administration tab under Software Management, Software
Updates. Refer to the Performing the Upgrade section for details of how to
apply software updates.
Application of the Factory Image does not stop any BCM services or require a
reboot of the system.
Note: Do not apply the Factory Image unless you are sure the upgraded
system is functioning correctly. You will not be able to perform a Software
Reset and restore a previous backup if the Factory Image is applied before
checking system functionality.
NN40011-002 Issue 1.2 BCM50 Rls 6.0
BCM50 Hardware & Installation
85