Installing a BCM50 Expansion Unit
Adding a BCM50 Expansion Unit increases the capacity of the BCM50 system
by providing a method of adding a media bay module (MBM). Each MBM you
add increases the number of trunks or extensions that you can connect to the
BCM50 system.
There are a maximum of 2 Expansion Units allowed
Each Expansion Unit can support 1 Media Bay Module
There is no bus sharing allowed (as on the BCM200/400)
Supported Media Bay Modules
The following Media Bay Modules are supported on the BCM50:
Digital Trunk Modules:
o DTM (digital trunk module)
o BRI (ISDN Basic Rate trunk module)
Analog Trunk Modules
o CTM4/8 (4/8-port analog CLID trunk module)
o GATM4/8 (global 4/8-port analog trunk module)
o ADID4/8 (4/8-port analog direct inward dial)
Digital Station Modules
o DSM16(+)/32(+) (16/32-port digital station module)
Analog Station Modules
o ASM8/8+ (8-port analog station interface)
o GASM8 (global 8-port analog station interface)
Combination Modules
o 4/8x16 Combo (4/8 analog trunks, 16 digital stations,
combination of CTM4/8 & DSM16)
o G4/8x16 Combo (global 4/8 analog trunks, 16 digital stations,
combination of GATM4/8 & DSM16)
Special Modules
o R2MFC
NN40011-002 Issue 1.2 BCM50 Rls 6.0
BCM50 Hardware & Installation
23