Installing The Bcm50 Wall Mount Bracket - Avaya BCM50 Hardware Installation Manual

Hide thumbs Also See for BCM50:

Table of Contents

BCM50 Hardware & Installation

7. If you want to further secure the unit, use four of the self-tapping

screws supplied with the rack mount kit to attach the unit to the rack

mount shelf. Make sure the screw holes in the unit are aligned with the

holes in the rack mount shelf. Then drive the four screws through the

holes in the bottom of the shelf and into the screw holes in the bottom

of the unit.

Installing the BCM50 Wall Mount Bracket

1. Place the wall mount bracket on the backboard and mark the location

of the center keyhole-shaped screw hole on the plywood backboard

2. Install one #8 x 2 cm (#8 x 0.75 in.) round-head wood screw in the

backboard.

3. Do not tighten the screw head against the backboard. Leave

approximately 0.5 cm (0.25 in.) of the screw exposed from the

backboard.

4. Prepare the wall mount bracket by removing the alignment tabs: If this

is the only unit in the BCM50 system, remove the alignment tabs on the

right side of the wall mount bracket. If this is the last unit on BCM50

system with multiple units, remove the alignment tabs on the left side of

the wall mount bracket.

5. Hang the wall mount bracket on the mounting screw.

6. Use a level to make sure the wall mount bracket is level.

7. Install two #8 x 2 cm (#8 x 0.75 in.) round-head wood screws into the

screw holes in the wall mount bracket

8. Tighten the three wood screws against the wall mount bracket.

9. Open the cable management door.

10. Install two #8 x 2 cm (#8 x 0.75 in.) round-head wood screws into the

screw holes in the cable trough.

11. If the BCM50 system has more than one unit, place the additional wall

mount bracket on the backboard on the right side of the existing wall

mount bracket. Use the alignment tabs to ensure the two wall mount

brackets are properly aligned.

12. Use three #8 x 2 cm (#8 x 0.75 in.) round-head wood screws to secure

the wall mount bracket to the backboard

13. Open the cable management door.

NN40011-002 Issue 1.2 BCM50 Rls 6.0

Table of Contents