Preparing The Multi-Image Hard Drive - Avaya BCM50 Hardware Installation Manual

BCM50 Hardware & Installation
18. Fasten the hard disk assembly to the main unit with two screws. Use
only the supplied screws, since other screws can damage the unit.
19. If you have just installed a Multi-Image hard drive, please now proceed
with the Preparing the Multi-Image Hard Drive section.
20. Perform a restore or manual reprogram of the system.

Preparing the Multi-Image Hard Drive

The Multi-Image Hard Drive field Replaceable Unit contains multiple BCM
software images. This allows for a common hard drive FRU to be installed in
either a BCM50 or BCM450 chassis, and offers a range of software releases
to be applied to the BCM having the hard drive replaced.
Once installed, the preparation process involves powering up the BCM,
connecting to the BCM via a SSH client such as PuTTY to access the
command menu, and selecting the correct software version for the BCM. On
process completion, all non-required images will have been erased, and the
BCM will boot up ready for a restore of a previous backup, or manual re-
programming via the System Start Up process (refer to the System Start Up
Guide).
Note: Perform the preparation process from a PC connected to the OAM port
of the BCM.
Use the following procedure to select the required software release of the
Multi-Image hard drive.
52 NN40011-002 Issue 1.2 BCM50 Rls 6.0