BCM50 Hardware & Installation
Installing the Wiring Field Card (WFC)
You install the optional wiring field card (WFC) in the cable management tray
of the BCM50 wall mount bracket.
To install the WFC:
1. Clear the WFC installation area of all cables.
2. Place the WFC in the installation area with the 50-pin header/cable
connector at the top.
3. Slide the WFC down until it is at the bottom of the installation area and
held in place by the three clips.
4. Press the WFC firmly at the top left corner, center, and right tabs.
5. The WFC snaps into place.
6. Optional – Install the three screws to secure the WFC in place.
62
NN40011-002 Issue 1.2 BCM50 Rls 6.0