Server (Rear View) - Fujitsu PRIMERGY RX200 S4 User Manual

1.3.2 Server (Rear View)

a b c d
a Keyboard connector (6-pin) (
A keyboard is plugged in.
b Mouse connector (6-pin) (
c LAN port 1 (
An Unshielded Twisted Pair (UTP) cable is plugged in. For 1000Mbps connection, a cable
conforming to category 5 enhanced is required.
The meanings of the two LEDs are shown in the table below.
LED
location
Left
Right
Although the left LED may light green without connecting the LAN cable, this is not failure. The
LED changes to one of above statuses by connecting the LAN cable.
If the LED does not light up or blink when the LAN cable is connected, it may indicate a failure.
When there is no problem after checking the system requirements, contact an office listed in the
"Contact Information" of the "Start Guide".
d Rear maintenance LED (
When an error is detected in a server component, this LED lights or blinks yellow (OFF in
normal status).
When this LED lights or blinks, contact an office listed in the "Contact Information" of the "Start
Guide".
e System identification LED (
This LED is for maintenance. When pressing the system identification LED button on the front,
the front and rear system identification LEDs are lit blue so that the locations of devices being
maintained can be determined.
Also, this LED can be lit by using [system identification LED display] button on the ServerView.
f USB connector (
Connects peripheral equipment conforming to the USB standard (2.0 or 1.1).
e f g h
)
)
table: LAN connection status
LED status
Green
Blinks green
Off
Amber
Green
Off
)
)
ID
)
PRIMERGY RX200 S4 User's Guide
i j k
)
Connection status
Link is being established.
Data is being transferred.
Link is not established.
Connection is established at 1000Mbps.
Connection is established at 100Mbps.
Connection is established at 10Mbps or
the LAN is not connected.
l m n
25