Fujitsu PRIMERGY RX200 S4 User Manual page 177

The [Main] menu screen may not appear although the [F2] key is pressed.
In this case, press the [Ctrl] + [Alt] + [Delete] keys simultaneously and restart the server, then
start the BIOS Setup.
If you press the [F12] key while the message "<F2> BIOS Setup / <F12> Boot Menu" is dis-
played on the screen, the Boot menu screen will appear after the POST completes.
1. CD-ROM Drive
2. Diskette
3. +Hard Drive
4. Legacy LAN Card
5. Embedded RAID CD/DVD-ROM
< > Select <Enter> Confirm
Key operations in the BIOS Setup Utility
The roles of the keys used for BIOS Setup Utility settings are as follows:
table: List of key operations on the BIOS Setup Utility screen
Key
[F1]
[Esc]
[ ↑ ] [ ↓ ]
[ ← ] [ → ]
[-] [+]
[Enter]
[F9]
[F7]
Note the following when returning a setting value to an initial value by pressing the [F9] key.
• When an onboard software RAID is not used, check that the setting value of the "S_ATA Mode" item
of " ATA Controller Config submenu" ( p.185) in the [Advanced] menu is "Compatible". When it is
set to "RAID", the system might not start.
• When using an onboard software RAID, select the "7.2.4 Boot Options Submenu" ( p.181) and
check that the boot order has no problem.
If the boot order of the Embedded RAID CD/DVD-ROM is the lowest, the system might not be
booted from a CD/DVD.
Boot Menu
Switches the detailed information display on and off.
When the submenu screen is displayed, the submenu closes and the screen returns
to the previous menu. When the menu screen is displayed, this utility closes.
Scrolls through the menu option list.
Switches between menus.
Changes the value of an item.
Selects an item. For items where
Resets each item to the default value. (The default value may vary from the value
set at the time of purchase.)
"Local IP address", "Subnet mask", and "Gateway address" in "
submenu" ( p.191) are not reset.
Resets an item to its previous value.
PRIMERGY RX200 S4 User's Guide
Description
is displayed, a submenu appears.
LAN Settings
177