For Windows Server 2003 - Fujitsu PRIMERGY RX200 S4 User Manual

Chapter 8 Operation and Maintenance
6
Perform the settings as required, and click [Next].
The restoration settings completion window appears.
7
Click [Finish].
The restoration start window appears.
8
Check the checkbox, and click [OK].
System restoration starts.
After the restoration has completed, the system is automatically rebooted. After rebooting, the
system is restored using the backup data.

8.6.2 For Windows Server 2003

Items required
• Windows Server 2003 CD-ROM
• Automated System Recovery floppy disk (created beforehand)
• Backup media (created beforehand)
• Driver disk (for RAID)
For drivers to be used and how to create driver disks, refer to "4.4 Creating Maintenance Tools and
Driver Disks" ( p.85).
1
Insert the Windows Server 2003 CD-ROM immediately after the server is
turned on.
Check that a floppy disk is not inserted in the floppy disk drive.
2
When an active area is set on the hard disk, the following message is displayed
at the bottom of the screen. Press any key while the message is displayed.
Press any key to boot from CD ...
The Windows Server 2003 setup screen appears.
3
The following message is displayed at the bottom of the screen. Press the [F6]
key.
Press F6 if you need to install a third party
SCSI or RAID driver ...
234
For operation with a BitLocker drive encryption set, perform the encryption settings again after
the system restoration.
Because this message is displayed for only a short time after the setup screen (blue
screen) is displayed, press the [F6] key immediately after the screen changes blue.