Server (Rear View) - Fujitsu PRIMERGY TX200 S2 User Manual

1.3.2 Server (Rear View)

g
h
j
k
l
n
a Power supply unit
When Power Supply Conversion kit is used, two power supply units are installed to enable the
redundant power function.
b Outlet (on the standard power supply only)
This cannot be used. Do not connect a power cable of peripheral devices.
c Inlet
Power cables are plugged in.
d Main switch (on the standard power supply only)
Turn this switch to "1" to turn on the main power of the server.
Once the main power is turned on, you do not have to turn this switch every time you start up the
server.
e Power status LED (on the redundant power supply only)
This LED is on, depending on the power supply status as follows.
LED status
Lights in green
Lights in amber
Off
Power supply unit
(non redundant)
a
b
c
d
i
m
table: Meaning of the Power Status LED
Power supply unit status
In normal mode (operating)
In normal mode (standby)
Power not supplied (power off)
PRIMERGY TX200 S2 User's Guide
Power supply unit
(redundant)
a
c
e
o
f
1
25