Fujitsu PRIMERGY RX200 S4 User Manual page 117

IEEE802.3ad dynamic link aggregation
Select this mode when connecting a team to a switch which supports IEEE802.3ad compliant Link
Aggregation Control Protocol (LACP). In this mode, all adapters must run at the same speed, and all
ports in the team must be connected to the same switch.
Also, this mode is only available for Teaming on the LAN card.
Creating a team
1
Click [Start] – [Administrative Tools] – [Computer Management] to start Intel
PROSet.
2
Click [Network adapters] under [Device Manager] and double-click a LAN
adapter to be incorporated in a team.
3
Click the [Teaming] tab, select [Team with other adapters] and click [New
Team].
4
Enter a team name and click [Next].
5
Check the LAN adapter to be incorporated in the Team and click [Next].
When using an onboard LAN for remote operation via RemoteControlService, do not check the
onboard LAN (Do not incorporate the onboard LAN in the Team).
6
Select a Teaming type with which a Team will be created.
Select the following depending on the Teaming type:
• AFT type: "Adapter fault tolerance"
• ALB type: "Adaptive load balancing"
• SFT type: "Switch fault tolerance"
• Static link type: "FEC/GEC Generic Trunking"
• Dynamic link type: "IEEE802.3ad dynamic link aggregation"
7
Click [Finish].
8
Click [OK] to close the property window for created Teaming adapter.
The property window for the LAN adapter is displayed.
When the message "This team includes an adapter other than Intel
"One or more adapters in the team do not support ****. **** is disabled." is displayed, click
[OK].
PRIMERGY RX200 S4 User's Guide
®
, and **** cannot be used." or
®
117