Fujitsu PRIMERGY RX200 S4 User Manual page 103

L2 Switch
LACP
FEC/GEC Generic Trunking
In this mode, configure a team using FEC/GEC Generic Trunking.
All the team members must be connected to the same switch where FEC/GEC Generic Trunking is set.
Also, a standby member cannot be set in this mode.
L2 Switch
FEC/GEC
Generic
Trunking
Errors that teaming can detect
For Smart Load Balancing and FEC/GEC Generic Trunking, only a link down error between a LAN
card (onboard LAN) and the switch it connects with, and the equivalent errors lead to switching of the
route. Therefore, if only the switch or LAN card (onboard LAN) is partially damaged and the route
being used is sound at the link level, the route will not be switched in the team, but the communication
with the Team may become an error.
When the mode is 802.3ad Link Aggregation using Link Aggregation Control Protocol (LACP), the path
is switched from the failed port to the normal port according to LACP protocol.
PRIMERGY RX200 S4 User's Guide
PRIMERGY
LACP Team
NIC1
NIC2
PRIMERGY
FEC/GEC Team
NIC1
NIC2
103