Jumper Pins/Switch Block Settings - Fujitsu PRIMERGY RX200 S4 User Manual

Chapter 7 Configuring Hardware and Utilities
7.1 Jumper Pins/Switch Block
Settings
This section explains the jumper pins and switch block settings on this server.
Jumper pin/Switch location
The jumper pin and switch are located on the baseboard as shown below.
[Rear]
Jumper pin settings
The jumper pin settings are as follows:
1 2 3
Jumper
JP2
174
JP2 Switch block
:Short
table: Jumper pin settings
Settings
1-2 (default) Keeps the information stored in CMOS.
2-3 Clears the information stored in CMOS.
[Front]
Description