Fujitsu PRIMERGY RX200 S4 User Manual page 185

Item
USB Rear
ATA Controller Config
Mouse Controller
Onboard Video
LAN Controller
LAN1 Remote Boot
LAN2 Remote Boot
ATA Controller Config submenu
Sets the Serial ATA.
Item
S_ATA Mode
P_ATA Maps To
Primary IDE Channel
Secondary IDE Channel
table: Items on the Peripheral Configuration Submenu
Setting
• Enabled (Initial value)
• Disabled
Configures additional settings.
" ATA Controller Config submenu" (p.185)
Auto Detect
(Unchangeable)
Enabled (Unchangeable)
LAN1&2 (Unchangeable)
• Disabled (Initial value)
• PXE
• iSCSI
table: Items on the ATA Controller Config submenu
Setting
Compatible
(Unchangeable)
RAID (Unchangeable)
Disabled (Unchangeable)
Enabled (Unchangeable)
Enabled (Unchangeable)
PRIMERGY RX200 S4 User's Guide
Description
Sets whether or not to use the USB connector on the
back.
Sets whether or not to use the mouse connected to
the mouse connector.
Sets whether or not to enable the onboard video
controller.
Sets whether or not to enable the onboard LAN
controller (channel 1, or channel 1 & 2).
Sets whether or not the OS may be loaded from the
server. This function is used especially when no
floppy disk drive or hard disk drive are installed, or
when both are turned off.
Description
Sets the Serial ATA Controller mode in RAID
configured SAS models, SAS and SATA models
where RAID is not configured, and diskless models
where RAID is not configured.
Sets the Serial ATA Controller mode if RAID is
configured in the SATA model.
Sets the Parallel ATA controller mode.
Sets whether or not to enable the Primary IDE
Channel.
Sets whether or not to enable the second IDE
Channel.
185