Dp To Dtmf Signal Conversion - Panasonic DBS576 Technical Manual

Section 700 - Operation
Hardware Requirements
• N/A
Related Programming
• FF1-0-03: Extension COS (Manual DND Override Send)
• FF1-0-03: Extension COS (Forced DND Override)
• FF1-0-03: Extension COS (DND Set/Clear)
• FF1-0-03: Extension COS (DND Set/Clear Other)
• FF1-2: Dial Plan
• FF3: Extension COS
Considerations
• Forced DND override is available.
• DND override function is available by Busy Override code.

DP to DTMF Signal Conversion

Description
Dial Pulse (DP) to Dual Tone Multifrequency (DTMF) Signal Conversion allows you to switch from
DP to DTMF signaling when using a DP trunk. For instance, if you dial into a Voice Mail system
using a DP trunk, you can switch to DTMF signaling to communicate with the Voice Mail system.
The System can automatically change DP to DTMF tones based on the incoming and outgoing timers.
Operation
To switch from DP to DTMF dialing:
1. Press the * key or the # key.
Hardware Requirements
• N/A
Related Programming
• FF1: DTMF
• FF2: DP to DTMF (Outgoing)
• FF2: DP to DTMF (Incoming)
Considerations
• N/A
576-36-700
Action
DBS 576 (USA) issued October 2000
Chapter 5. Key Telephone Features
Result
5-47