Hot Dial Pad - Panasonic DBS576 Technical Manual

Chapter 5. Key Telephone Features
Operation
To answer calls using the Headset Operation:
Note: If Headset mode is already on, the following procedure turns it off. If Headset mode is off,
this procedure turns it on.
1. Pick up the handset or press the ON/OFF key.
2. Press the PROG key.
3. Enter 90 for Headset mode.
4. Replace the handset or press the ON/OFF key.
Hardware Requirements
• A headset must be installed.
Related Programming
• FF1-0-3: Extension COS (Dial Tone Stop)
• FF1-2: Dial Plan
• FF3: Extension COS
Considerations
• Intercom Dial Tone is enabled/disabled regardless of Headset mode (per programming for the
Extension Class of Service [COS])

Hot Dial Pad

Description
The dial pad on digital key phones can be designated as "hot" on an extension-by-extension basis.
The Hot Dial Pad allows the user to initiate a call without going offhook. Extensions with the Hot
Dial Pad enabled can initiate calls by pressing any of the numeric keys (0-9). The "*" and "#" keys
are not hot.
The Dial Pad can be hot under these conditions:
• When the extension is idle
• When the extension is holding a call
• When the extension is receiving a page.
The Dial Pad cannot be hot under these conditions:
• When a call is ringing at the extension (intercom or CO)
• When the extension is on a call.
5-58
Action
DBS 576 (USA) issued October 2000
Section 700 - Operation
Result
Intercom dial tone
576-36-700