Log Set Installation - kozy heat Windim-WDM 56101 Installation And Operation Manual

#WDM-50B LOG SET INSTALLATION
ATTENTION: If installing optional brick refractory please do so now before installing log set. Follow instructions included with kit.
If converting to LP (propane) gas do so now before installing log set. Follow instructions included with kit.
NOTE: Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on logs and glass.
STEP 1: #W5, #W6, #W7 LOG PLACEMENT
W6
Figure 22a
Position log #W5 by aligning cut out over pilot assembly and slots in bottom of log over burner cover brackets.
Press down slightly to secure. Position #W6 and #W7 logs onto burner center.
NATURAL GAS MODELS: Position backsides of #W6 & #W7 logs up against burner tube.
STEP 2: #W8, #W9, & #W10 LOG PLACEMENT
Position #W8, #W9, & #W10 logs, aligning to notches in base logs.
W8
Figure 22b
Randomly place „Klinkers" in this area. Do not place „Klinkers" directly on burner ports.
Use a steel or stiff bristle nylon brush to distribute Rock Wool Embers onto logs and burner.
W5
W7
W9
W10
PAGE 22