Components List; Installation Overview; Placement Clearance Requirements - kozy heat Windim-WDM 56101 Installation And Operation Manual

#56101 COMPONENTS LIST

PART NUMBER
WDM-770 Millivolt Control Board Assembly
700-203 Manual Gas Shut-off Valve
OCK-035 Burner Assembly
WDM-50B Log Package
936-005 Glass Valance
700-07T Glass with Gasket
OCK-S55A LP Conversion Kit
600-083 Receptacle / Speed Control Assembly
900-085 4" Restrictor Plate

INSTALLATION OVERVIEW

NOTE: The qualified installer should follow the procedure best suited for the installation.
1. Frame an opening for the fireplace, allowing for vent installation and type of installation.
2. If masonry (optional) is used, prepare foundation for the masonry load. A lintel is required to support the added weight above fireplace.
3. Attach nailing flanges to fireplace.
4. Insert fireplace into framing.
5. Install hearth (if applicable).
6. Complete gas line installation.
7. Complete electrical hook-up. Install any standard or optional electrical components at this time.
8. Complete venting installation.
9. Secure fireplace to flooring through holes in outer box bottom and to framing with nailing flanges. Verify all clearances at this point.
10. Install facing material, mantel or cabinetry, allowing room for optional full face doors, if applicable.
11. Install logs.
12. Install grills and optional decorative doors / faces.
13. Verify proper operation of fireplace and all components.

PLACEMENT CLEARANCE REQUIREMENTS

This fireplace must be installed on a level surface capable of supporting the fireplace and venting.
Fireplace must be placed directly on wood or non-combustible surface (not linoleum or carpet) extending the entire depth and width of
fireplace.
Due to high surface temperatures, fireplace should be located out of traffic and away from furniture and draperies.
This fireplace may be installed in a bedroom.
Please be aware of the large amount of heat this fireplace will produce when determining a location.
SPECIFICATIONS
DESCRIPTION
PAGE 9