Table of Contents
Advertisement
LIGHTING AND SHUTDOWN (cont.)
LIGHTING
1.
Set thermostat to lowest setting, if installed.
2.
Turn off all electrical power to appliance. (Fan).
3.
Open lower grill to access gas valve & controls.
A. Push gas control knob in slightly and turn clockwise to
"OFF". Wait five (5) minutes to allow any gas that may
have accumulated inside firebox to escape. If you then smell
gas, STOP! Follow safety information on previous page
and front cover of this installation manual. If you don‟t
smell gas, go to next step.
NOTE: Gas control knob cannot be turned from
"PILOT" to "OFF" unless knob is pushed
in slightly. Do not force.
B.
Locate pilot - follow metal tube from gas control. (Located
inside combustion chamber).
C.
Push gas control knob on gas valve in slightly and turn
counterclockwise to „PILOT‟. Push valve knob in and hold
while repeatedly pressing piezo igniter button until pilot is
lit while continuing to hold in gas control knob.
D. Hold gas control knob in for one (1) minute after pilot is lit.
Release gas control knob. If pilot goes out, repeat steps C-D.
When pilot is lit, proceed to step E.
CAUTION: If knob does not pop up when released,
stop and immediately call your service
technician or the gas supplier. If pilot
will not stay lit after several tries, turn
gas control knob to OFF and call your
service technician or gas supplier.
E.
Push gas control knob in slightly and turn counter-
clockwise to „ON‟. The burner can now be turned
„ON‟ by depressing ON/OFF rocker switch located
beside valve, or wall switch, OR by setting thermostat
or remote control to desired setting.
F.
Turn on all electric power to appliance (if applicable).
NOTE: When fireplace is initially lit, condensation
will appear on the glass; this is normal in all
gas fireplaces and will disappear after
several minutes.
A
B
C
D
E
Figure 27a
PAGE 27
5 MINUTES
PILOT
PILOT TUBE
1 MINUTE
Advertisement
Table of Contents
Troubleshooting
