Panasonic S-45PU1E5 Technical Data & Service Manual page 370

1
If there is an obstacle that is higher than the unit on the discharge side.
Pattern 2
(There is no limit to the height of theobstacle above the discharge.)
If the upper part is open
For separate installation location
1
If there are obstacles above the unit
For separate installation location
1
• The dimensions for H, A and L are shown in the
following table.
L H
H < L
• Cover the bottom part of the pedestal or mount
so that air does not go through it.
For multiple units (up to 2 units)
2
• The dimensions for H, A and L are shown in the
following table.
L H
H < L
• Cover the bottom part of the pedestal or mount
so that air does not bypass it.
• A limit of only 2 units can be installed.
(D) Stacking installation setup
• Stack up to 2 tiers.
• A dimension of approximately 400 mm is required for the second tier outdoor unit's drain pipe and space for
maintenance of the fi rst tier outdoor unit.
• Close A section (the space between the upper and lower level outdoor units) so the outtake air does not bypass it.
If there are obstacles at the discharge
1
A section
(E) For multiple row installation (on the roof, etc.)
For one row installation setup
1
• The dimensions for H, A and L are
shown in the following table.
• The above mentioned distance is required for optimal unit performance.
Allow as much space as possible in order to obtain the best performance from the units.
A
100
Install a pedestal or mount so that L
A
200
Install a pedestal or mount so that L
u (
A section
(unit: mm)
For multiple units (more than 2 units)
2
H
H
n : t i m m ) If there are obstacles at the intake
2
A section
For multiple units (more than 2 units)
2
A
L H 200
H < L Installation not possible
1-360
(unit: mm)
(unit: mm)
(unit: mm)
u ( n
A section
(unit: mm)
: t i m m )