Base Setup Model; Winged Model; Model Name; Stick Mode - GRAUPNER mx-20 Hott Programming Manual

Base setup model

Model-specifi c base settings for winged aircraft models
Before programming specifi c parameters, there are
some basic settings to be made which effect the
currently active model memory.
Select the "Base setup model" menu with the arrow
keys of the left or right touch pad then press the center
SET button in the right touch pad.
Suppress models
Base setup model
Model type
Ser vo adjustment

Stick mode

Control adjust

Model name

BASIC SETTINGS, MODEL
Mod.name
Stick mode
RF BIND n/a
RF transmit
BD1
Change to the next screen page by pressing the
button briefl y. This will open a screen of characters for
entry of the model's name. A maximum of 9 characters
can be used to specify a model name.
! " # $ % & ' ( ) + , – . / 0 1 2
3 4 5 6 7 8 9 : ; ? @ A
F G H I J K L M N O P Q R S T U V W X
Y Z [ ¥ ] ^ _ ` a b c d e f g h i j k
Mod Name GRAUB
68 Detail program description - Base setup model
Select the desired characters with the arrow keys of the
left touch pad. Move to select the next character position
by pressing the  arrow key of the right touch pad or its
button. Simultaneously pressing the  or
center SET
 of the right touch pad (CLEAR) will place a space
character at the position.
Positioning to any character position within the entry
fi eld can be done with the  keys of the right touch
pad.
A return to the previous menu screen is accomplished
by pressing the center
After entering the model name it will appear in the base
screen of the "Model select" menu and in the sub-menu
for the "Copy /Erase" menu item.
Stick mode
1 "MODE 1" (throttle left)
n/a
Stick forward Motor full throttle
OFF
BD2
Stick back
SET
"MODE 3" (throttle right)
Stick forward Motor full throttle
Stick back
B C D E
There are four fundamental options for assigning the
four control functions (aileron, elevator, rudder and
throttle/brake fl ap) for a winged aircraft model to the two
joysticks. Just which of these options is chosen depends
on the individual preferences of the individual model
pilot.
ESC button in the left touch pad.
"MODE 2" (throttle left)
Motor full throttle Stick forward
Motor idle Motor idle Stick back
"MODE 4" (throttle left)
Motor full throttle Stick forward
Motor idle Motor idle Stick back
Select the "Stick mode" line with the  arrow keys
of the left or right touch pad. The option fi eld will be
enclosed in a frame.
BASIC SETTINGS, MODEL
Mod.name GRAUBELE
Stick mode
RF BIND n/a
RF transmit
Press the SET button. The currently displayed stick
mode will be displayed in inverse video. Now use the
arrow keys of the right touch pad to select from among
options 1 through 4.
Pressing simultaneously on the  or  keys of the
right touch pad (CLEAR) will return the option selection
back to stick mode "1".
Pressing the SET button again will deactivate option
selection so that you can change to another line.

Bound receiver

Graupner HoTT receivers must be "instructed" to
communicate exclusively with one particular model
(memory) in a Graupner HoTT transmitter. This
procedure is known as "binding" and must only be done
once for every new receiver/model memory location
combination (and can be repeated anytime).
Important notice:
During the binding procedure be sure the
transmitter's antenna is always far enough away
from the receiver's antenna. To be on the safe side,
keep them at least one meter apart. Otherwise you
run the risk of a faulty connection to the return
channel and malfunctions will result.
1
n/a
OFF
SEL