Export To Sd Card - GRAUPNER mx-20 Hott Programming Manual

Once selection of the model memory has been
confi rmed by pressing the SET button, a confi rmation
request will appear.
modell really
01 ULTIMATE
03  frei
to be copied?
NO YES
A NO response will cancel the process and return the
screen to the originating screen. If the  YES response
is selected and confi rmed by activating the
then the selected source model will be copied into the
selected model memory destination.
Notice:
In addition to model data, binding data is also copied by
this process. This means that a receiver system which
was/is bound to the original model memory can also be
operated by its copy without establishing the bond again.
Export to SD
Select the "Export to SD" sub-menu with the  arrow
keys of the left or right touch pad and press the
button.
Erase model
Copy model–>model

Expor t to SD
Impor t from SD
Copy flight phase
Select the model to be exported with the  arrow
SET button
keys of the left or right touch pad.
expor t to SD-CARD:
01
02
03
04
05
After confi rming the selected model memory by pressing
the SET button, a confi rmation request will appear.
modell
expor t ?
A NO response will cancel the process and return the
screen to the originating screen. However, if the  YES
response is selected then confi rmed by pressing the
button, the selected model will be copied to the SD card.
SET
=>
=>
=>
=> =>
=> =>
GRAUBELE R12
ULTIMATE R12
STARLET R12
BELL47G –––
 frei 
01 ULTIMATE
SD-Kar te
NO YES
SET
Notice:
• Should the notice ...
SD-CARD
INSERT
OK
... appear instead of a screen for model selection,
there is no SD card in the transmitter's card slot, see
page 22.
• In addition to model data, binding data is also copied
by this process. This means that a receiver system
which was/is bound to the original model memory
can also be operated in the SAME transmitter by its
copy without establishing the bond again.
• An exported winged aircraft model will be stored
on the memory card in the \\Models\mx-20 folder
with a fi lename format of "aModellname.mdl"
and a helicopter model with a fi lename format
of "hModellname.mdl". On the other hand, if a
"nameless" model is exported, its data will be stored
on the memory card under "ahNoName.mdl" or
"hNoName.mdl", as appropriate.
• Some special characters that can be used in model
names are subject to specifi c restrictions associated
with the FAT or FAT32 fi le system used by the
memory cards and these special characters will be
replaced during the copy process with a tilde (~).
• A model fi le already on the memory having the same
name as the fi le to be copied will be overwritten
without warning.
Detail program description - Copy / Erase 65