Change The Values In An Input Field; M-Sel (Model Selection); Reverse (Servo Reverse); Trim - GRAUPNER X-8E Manual

Change the values in an input field

M-SEL (Model Selection)

BACK
01 MODEL 1
02
MODEL 2
03 MODEL 3
04 MODEL 4
05 MODEL 5
MODEL 6
06
07 MODEL 7
08 MODEL 8
MODEL 9
09

REVERSE (Servo Reverse)

NORMAL
BACK
ST
TH
NORMAL
NORMAL
CH3 CH4
NORMAL NORMAL

TRIM

NORMAL
BACK
ST
SV/TR 0%
TX/TR
0%
CH 3 CH 4
0%
SV/TR
TX/TR
0%
S1008_X-8E_jh_V1
The following three buttons are visable on the lower part of the
display of many of the following menus. To raise or lower a value
by pressing the <+ or -> buttons.
through the curved back-arrow button.
Model settings can be managed and saved into memory slots
by choosing from the following options:
SEL - Change active model memories.
NEXT
IMP.M - Import model memories from the SD card.
SEL
IMP.M
EXP.M - Export model memories to the SD card.
EXP.M
RES - Reset a model memory to the factory presets.
RES
Warning:
CPY
CPY - Copy the actual model memory in a new model mem-
ory.
The servo operates in two directions:
SERVO
Normal - Reverse
To change servo directions, tap the NORMAL/REVERSE but-
ton of the related servo to toggle between options. If changing
the throttle direction, a safety warning will appear. Tap YES or
NO to verify the selection and the change will take effect.
This trim function allows for the entire servo travel to be moved,
SERVO
i.e. full deflection position changes.
TH
In the second line is displayed the respective trim value that has
0%
been set through the buttons.
0%
Tap on the related button. Change the values by pushing the <+
or -> keys. Press the curved arrow key to reset to the default
value (0%).
0%
0%
Reset the default value
All personal settings will be deleted!
NORMAL
BACK SERVO
ST
TH
Warning
NORMAL
NORMAL
Are you sure?
CH3 CH4
YES NO
NORMAL NORMAL
27 / 48