GRAUPNER mx-20 Hott Programming Manual page 114

Roll 3 0%
Nick ––– 0%
Tail ––– 0%
EXPO
normal
SEL
If you select the right-handcolumn at the lower edge
of the display marked with SEL and activate the value
fi eld by briefl y tapping the center SET
touch pad, you can use the arrow keys on the left or
right touch pad to alter the Expo value shown in the
highlighted fi eld separately for each of the two switch
positions:
Now, for example, you have the opportunity to fl y with
a linear curve characteristic with the switch in one
direction, and to pre-set a value other than 0% in the
other switching direction:
Roll 3 33%
Nick ––– 0%
Tail ––– 0%
EXPO
nor mal
SEL
If you tap the  or  keys on the right touch
pad (CLEAR) at the same time, this will reset a value
changed in the highlighted fi eld back to 0%.
114 Detail program description - Control adjust
Some examples of Expo values:
Expo = +100%
Stick deflection
In each of these examples, the Dual Rate value equals
key on the right
100%.
Combining Dual Rate and Expo
If you have entered values for both the Dual Rate
and the Expo function, the effect from on function
is superimposed on the other, as shown in these
examples:
Expo = +100%, DR = 125%
Stick deflection
Asymmetric setting of Dual Rate and Expo
To make an asymmetric setting, i. e. a Dual Rate or Expo
setting dependent on the direction of the respective
joystick, fi rst access the "Control switches" menu and
assign one of the C1 ... C4 control switches – "C3", for
example – your chosen transmitter control, e. g. control
3 for the pitch-axis function. Leave the switching point
at the joystick's neutral position (0%), however. Now
return to the "Dual Rate / Expo" menu and select the
corresponding control function ("Nick" in this example).
Expo = +50% Expo = –100%
Stick deflection Stick deflection
Expo = +100%, DR = 50% Expo = –100%, DR = 50%
Stick deflection Stick deflection
Activate "Switch assignment" and tap the center
SET key briefl y on the right touch pad to switch to
the expanded switches. Here, use the arrow keys to
continue switching to the control switch "G3" that you
defi ned previously:
Roll ––– 100%
HR ––– 100%
Control / fix sw
SR ––– 100%
C1 C2 C3 C4
DUAL
FXi C1i C2i C3i C4i
normal
SEL
Tap the center SET key on the right touch pad to confi rm
the assignment of this switch:
Roll ––– 100%
Nick C3 100%
Tail ––– 100%
DUAL
normal
SEL
Now use one of the arrow keys to move to the right
column and then move the pitch-axis joystick to the
appropriate end-point in order to enter a separate Dual
Rate value for each direction, e. g. for "Pitch-axis up" ...
Roll ––– 100%
Nick C3 77%
Tail ––– 100%
DUAL
normal
SEL
and "Pitch-axis down":
FX