GRAUPNER mx-20 Hott Programming Manual page 265

of mixture specifi ed for the example compensates
directly for the FL-pos. setting, whereas ...
• ... in the other limit position, AIL and FL reach the
maximum downward offset prescribed by the mixer
percentage.
In order to set a – corrective – admix for the elevator, exit
the "Multi-fl ap menu" and return to the base screen of
the "Wing mixers" menu:
WING MIXERS
Multi-flap menu
Brake settings
AI RU 0%
FL EL +5% +5%
Thermal
In the two limit positions of the three-stage switch the
elevator is moved symmetrically in this example with
+5 % (true to side). If, on the other hand, you use a
proportional rotary control, the elevator is defl ected
according to the degree for the control position.
Then make the settings for the "Speed" fl ight phase in
the same manner.
Notice:
• The digital trimming of transverse, altitude and side
work independently of these settings – depending on
the setting selected in the "Joystick setting" menu,
page 92 – "Global" or for each "Phase".
• All setting values are model-dependent. Carry out
the settings on your fi nished model and/or during the
fl ight.
–––
–––
Detail program description - Control adjust 265