Non-Delayed Channels - GRAUPNER mx-20 Hott Programming Manual

Non-delayed channels

Channel-dependent delays to switching
Using the arrow keys on the left or right touch pad, page
to the menu option "Phase trim" in the multi-function
list:
Control switch
Phase settings
Phase assignment
Phase trim
Non-delayed chan
Timers (general)
Control switch
Phase settings
Phase assignment
Non-delayed chan
Timers (general)
Fl. phase timers
Tap the center SET key on the right touch pad to open
the menu shown below:
NONDELAYED CHANNELS
non-delay
normal
1 2 3 4 5 6
Normal
On the "Phase settings" menu, you will have set the
necessary switch times for fl ight phase transitions.
In this menu, you can now deactivate the transition delay
set previously, per fl ight phase and for individual control
channels – e. g. for the motor channel for electric models
or heading-lock systems for heli gyros, etc.
Switch over to the corresponding fl ight phase. This is
shown at the bottom left of the display.
Use the arrow keys on the left or right touch pad to
move the "" onto the corresponding channel and then
briefl y tap the center SET key on the right touch pad.
The switch icon changes from "normal" to "non-delay"
and vice versa. For example:
NONDELAYED CHANNELS
non-delay
normal
7 8 9 10 11 12
Normal
Note:
To access channels 7 ... 12, follow the description on
page 27: use the arrow keys  on the left or right
touch pad to go beyond the right edge of the screen and
back, as appropriate.
Detail program description - Control adjust 137