Model Selection - GRAUPNER mc-26 Programming Manual

Fail-Safe
setup
t.b.d.
Thr
too
high!
No
pupil
signal
inser t
SD card
OK
Power-on warning
is active!!!
actually not possible
voltage too low
Please select
Trainer connection?
ON OFF

Model selection

Model select
Copy / Erase
Suppress menus
Suppress models
Base setup model
Model type
01 M
02 free
 
03 free
 
04 free
 
05 free
 
06 free
 
14 / 80
Fail Safe setting not performed yet
Throttle or pitch control stick position or throttle limit for helicop-
ters too high
Connection between teacher and pupil transmitter disturbed
No SD or SDHC memory card in the card slot or card not readable.
Within the time set in the line
settings" menu the transmitter has not been used. In the display it
appears the warning and the
of the On/Off switch blinks and an acoustic warning alarm is emitted.
If the transmitter is still not being used it will autonomously switch
off after about three minutes.
In case of too low battery voltage a model change is not possible for
safety reasons. In the display appears a related message:
Should the "Wireless Teacher/pupil connection" used before the last
switch off of the transmitter be continued (CONTINUE) or inter-
rupted (INTERRUPT)?
Tap on the SET button to access the menu. Now you can see the list
of the available model memories. Selection of the desired model
memory through the  or  buttons of the left or right touch-pad.
Then tap on the SET button.
Create a new model memory, select an empty model memory:
You will be requested to select the desired model type among the
five available model types.
R12
Select through the  or  buttons the related symbol and then tap
on the SET button. In this way the selected model memory will be
installed with the selected model type.
"Switch-on warning" of the "general
WARNING LED on the right side
33028_mc_28_Teil2_jh