Phase Trim" (Winged Model) - GRAUPNER mx-20 Hott Programming Manual

Phase trim
Flap settings specifi c to fl ight phases
Using the arrow keys on the left or right touch pad, page
to the menu option "Phase trim" in the multi-function
list:
Control switch
Phase settings
Phase assignment
Phase trim
Non-delayed chan
Timers (general)
Tap the center SET key on the right touch pad to open
the menu shown below:
 Normal 0%
normal ELEV
Depending on the settings made on the "Aile/fl aps"
line from the "Model type" menu (page 82) and on the
"Phase settings" menu, this menu makes available a
set of control functions – 1 for EL ...
 Normal 0%
Normal ELEV
... and up to 4 for EL, RU, AI and AI2 – for the
confi guration of trim settings that are specifi c to fl ight
phases. The setting of the fl ight phase switches – to be
defi ned beforehand on the "Phase assignment" menu
136 Detail program description - Control adjust
– determines the line that is chosen. An asterisk marks
the fl ight phase currently active. At the same time, the
name of the respective fl ight phase is also shown at the
bottom left of the screen. You can enter settings only for
the currently active fl ight phase, e. g.:
Normal 0%

Launch 0%
Thermal 0%
Dist. 0%
Launch ELEV
"ELEV" column In this column, you can store a phase-
specifi c elevator trim setting.
Important notice:
Settings made in this column have an
immediate effect on elevator trim and,
accordingly, the trim setting display. In
turn, the elevator trim lever affects the
values of this column either "globally"
or "phase-specifi cally", depending on
the "global/phase" setting made on the
"Elev" line of the "Stick mode" menu.
"AILE", "FLAP", "FLAP2"
The values in these columns (max. 3)
are identical to those in the "Fl.pos" (fl ap
position) line on the "Multi-fl ap menu"
within the "Wing mixers" menu. For this
reason, any changes made always affect
the other menu directly – and vice versa.
Normal

Launch
Thermal
Dist.
Launch
0%
0%
Note:
0%
If present, you can access the "FLAP" and "FLAP2"
0%
columns by using the arrow keys  on the left or right
touch pad to go beyond the right edge of the screen and
AILE
back, as appropriate.
After selecting the appropriate column, by using the
arrow keys on the left or right touch pad and then
briefl y tapping the center
pad, you can then use the arrow keys to set the values
independently of one another, within a range of ±150%.
If you tap the  or  keys on the right touch
pad (CLEAR) at the same time, this will reset values
changed in the highlighted value fi eld back to 0%.
0% 0%
0% 0%
0% 0%
0% 0%
FLAP FLAP2
SET key on the right touch