GRAUPNER mx-20 Hott Programming Manual page 267

... triggered by the same switch, but with a delayed
startup of the drive motor connected to Output 10:
C.MIX10
Cur ve on
Input –100%
Output –100%
Point L –100%
normal
The function you programmed functions as desired
according to these suggestions – which you can verify
at any time after switching to the "Servo display" by
simultaneously pressing the keys  of the left touch
pad – then to, complete the programming, an arbitrary
switch, such as "SW 8" is assigned in the menu ...
"Control adjust"
... to the control channel used instead of the selected
proportional rotary control – in in these examples
"CTRL 8" to channel "9" – and the desired symmetric
or asymmetric time span is set in the "- Time +" column
for the amount of time in which the function should
ultimately take place:
Input 6 GL –––
Input 7 GL –––
Input 8 GL –––
Input 9 GL 8
typ
Input 9
Input10
Input11
9 10
Input12
Notice:
In the course of the switch assignment, always bear in
mind that you can also trigger multiple functions with
one switch! For example , with the same switch a landing
gear connected to Output 6 can be started and, as
shown here as an example, the time-controlled landing
gear fl aps connected to Output 9 and/or the headlight,
etc.
(page 96)
0%
0%
0%
0%
offset
9.9 9.9
0.0
0.0
0.0 0.0
0.0 0.0
– time +
Detail program description - Control adjust 267