Toshiba e-STUDIO 200L Service Manual page 83

[F] High-voltage transformer
(1) Take off the connecting port cover
( P.2-37 "[O] Connecting port cover").
(2) Release the harness from 6 harness clamps.
(3) Remove 4 screws and take off the high-volt-
age transformer cover.
(4) Disconnect 7 connectors. Remove 2 screws,
release 2 locking supports, and then take off
the high-voltage transformer.
[G] Switching power supply
(1) Take off the left rear cover
( P.2-35 "[J] Left rear cover").
(2) Take off the left cover
( P.2-36 "[L] Left cover").
(3) Remove 2 screws and pull out the switching
power supply.
(4) Disconnect 7 connectors, release the har-
ness from 4 harness clamps.
June 2004 © TOSHIBA TEC
Harness clamp
Harness
clamp
Hight-voltage transformer cover
Fig. 2-65
Hight-voltage transformer
Fig. 2-66
Harness
clamp
Fig. 2-67
e-STUDIO200L/202L/230/232/280/282 OUTLINE OF THE MACHINE
2 - 49
Screw
2