Toshiba e-STUDIO 200L Service Manual page 230

(3) Remove the pulley, one-way clutch and 3 E-
rings. Then take off the pickup roller.
[R] Drawer feed clutch
(1) Take off the drawer feeding unit
( P.9-20 "[K] Drawer feeding unit").
(2) Disconnect the connector and release the
harness from the harness clamp.
(3) Remove 2 screws and take off the clutch
bracket and bushing.
Note:
Match the protruding portion of the clutch
with the position shown in the figure for
assembling.
e-STUDIO200L/202L/230/232/280/282 PAPER FEEDING SYSTEM
Pickup roller
9 - 24
E-ring
One-way clutch
Pulley
Fig.9-39
Connector
Fig.9-40
Bushing
Clutch bracket
Fig.9-41
June 2004 © TOSHIBA TEC
E-ring