Toshiba e-STUDIO 200L Service Manual page 181

[H] Inverter board
(1) Take off the carriage-1
( P.6-22 "[F] Carriage-1").
(2) Disconnect 2 connectors.
(3) Remove 2 screws and take off the inverter
board.
[I] Carriage wire / Carriage-2
(1) Take off the carriage-1
( P.6-22 "[F] Carriage-1").
(2) Install the wire holder jig to each pulley on
front and rear sides, not to loosen the car-
riage wire.
Note:
Refer to "3.7.1 Carriages" in the Service
Handbook for the installation direction of the
wire holder jig.
(3) Remove the tension springs on both front
and rear sides.
(4) Remove the carriage wires on both front and
rear sides.
June 2004 © TOSHIBA TEC
Fig. 6-40
Fig. 6-41
Tension spring
Carriage wire
Carriage wire
Fig. 6-42
e-STUDIO200L/202L/230/232/280/282 SCANNER
6 - 25
Inverter board
Wire holder jig
Tension spring
6