Toshiba e-STUDIO 200L Service Manual page 236

(11) Remove 1 each of the bushing, gear, pin and
gear in order.
Note:
When installing the gear, engage the convex-
ity of the one-way clutch and concavity of the
gear.
(12) Remove 4 screws and take off the transport
drive unit.
[V] Side cover opening/closing detection sensor
(1) Take off the ADU
( P.15-10 "[A] Automatic Duplexing Unit
(ADU)").
(2) Take off the bypass unit
( P.9-17 "[G] Bypass unit").
(3) Release the latches and take off the side
cover opening/closing detection sensor.
e-STUDIO200L/202L/230/232/280/282 PAPER FEEDING SYSTEM
Pin
Gear
Bushing
Transport drive unit
9 - 30
Gear One-way clutch
Fig.9-57
Fig.9-58
Side cover
opening/closing sensor
Fig.9-59
June 2004 © TOSHIBA TEC