Toshiba e-STUDIO 200L Service Manual page 305

(3) Remove 1 C-ring and 1 bearing from the
fuser roller front side.
(4) Remove 1 C-ring, 1 gear and 1 bearing from
the fuser roller rear side.
[F] Pressure roller
(1) Take off the fuser roller
( P.13-14 "[E] Fuser roller").
(2) Place the fuser unit with the pressure roller
on its bottom. Remove 2 screws and take off
the fuser unit entrance guide.
(3) Take off the pressure roller. Remove 2 E-
rings and the bearings on both ends of the
pressure roller.
Note:
The pressure roller is quite heavy. Do not
drop the roller when lifting up.
June 2004 © TOSHIBA TEC
Bearing
C-ring
Fig.13-17
Fig.13-18
Pressure roller
Bearing
E-ring
Fig.13-19
e-STUDIO200L/202L/230/232/280/282 FUSER UNIT
13 - 15
C-ring
Gear
Bearing
Fuser unit entrance guide
Bearing
E-ring
13