Toshiba e-STUDIO 200L Service Manual page 266

[N] Charger wire
* Length: 353 mm (tungsten wire), diameter: 0.06 mm
(1) Take off the transfer/separation charger
( P.11-15 "[M] Transfer/Separation
charger").
(2) Release 9 latches and take off the separation
supporter.
(3) Release 2 latches and take off the terminal
cover on the front side.
(4) Release 1 latch and take off the terminal
cover on the rear side.
(5) Remove the terminal and spring. Then take
off the transfer charger wire.
(6) Remove the cushioning material, disconnect
the terminal and remove the spring. Then
take off the separation charger wire.
Notes:
1. Insert the wire securely into the V-
grooves of the front and rear sides.
2. Do not twist the wire.
3. Do not touch the wire directly with bare
hands.
e-STUDIO200L/202L/230/232/280/282 DRUM RELATED SECTION
Separation supporter
Terminal cover
Cushioning material
Terminal
Spring
11 - 16
Fig.11-26
Fig.11-27
Transfer charger wire
Separation charger wire
Fig.11-28
June 2004 © TOSHIBA TEC