Toshiba e-STUDIO 200L Service Manual page 139

No. Message
44 Place the blank sheets in
bypass tray and select the
paper size
45 Place the blank sheets in
the same direction as the
originals
46 Place the same size blank
sheets as the originals
47 Place insertion sheets in
the bypass tray and select
the paper size
48 Select the same size
insert1 sheets as the origi-
nals
49 Select the same size
insert2 sheets as the origi-
nals
50 Set insert1 sheets in the
same direction as the origi-
nals
51 Set insert2 sheets in the
same direction as the origi-
nals
52 READY
(CHANGE THE PAPER
TYPE)
53 Set transparency film in A4/
LT direction
54 CHECK PAPER IN LARGE
CAPACITY FEEDER
55 CANNOT PUNCH THIS
SIZE PAPER
56 Remove paper from the fin-
isher
57 Cannot staple this size
58 Remove paper from the fin-
isher
59 Examine stapler
60 Check staple cartridge
61 Job interrupted job 1 saved Interrupt copying is accepted
62 Ready to resume job 1
63 Cannot use AMS mode
64 More than 200% is not
available
June 2004 © TOSHIBA TEC
State of equipment
Displayed when no paper is in the
selected feeder at Cover Sheet
Copying Mode
Displayed when the direction of
cover page is different from that of
other pages at Cover Copying Mode
Displayed when the paper size of
cover page is different from that of
other pages at Cover Copying Mode
Displayed when no insertion sheet is
in the selected drawer at Sheet Inser-
tion Mode
Displayed when the size of insertion
sheet (sheet 1) is different from that
of other pages at Sheet Insertion
Mode
Displayed when the size of insertion
sheet (sheet 2) is different from that
of other pages at Sheet Insertion
Mode
Displayed when the direction of
insertion sheet (sheet 1) is different
from that of other pages at Sheet
Insertion Mode
Displayed when the direction of
insertion sheet (sheet 2) is different
from that of other pages at Sheet
Insertion Mode
Displays when the printing is stopped
because of media type mismatch
Displayed when the selected paper
size is other than A4/LT at OHP
mode
Papers in LCF are set incorrectly
Displayed when the selected paper
size is not specified for hole punching
Displayed when the paper sizes are
mixed at Staple Sorting Mode
Displayed when the paper size is not
specified for stapling at Staple Sort-
ing Mode
Finisher is full of papers
Trouble in the stapler unit in finisher
No stapler in finisher section
Interrupt copying is cancelled (fin-
ished)
Displayed when reproduction ratio is
set to be over 200% at AMS Mode on
RADF
Displayed when reproduction ratio is
set manually to be over 200% on
RADF
5 - 5
Note
Set the reproduction ratio 200% or
below manually
Set the reproduction ratio 200% or
below
e-STUDIO200L/202L/230/232/280/282 CONTROL PANEL
5